- Keep pressing and holding the On/Off button as well as the Clean reset button for 5 seconds, or until the yellow light begins to flicker, and then release the buttons (yellow light should remain blinking) Place the bottle of Scotsman “Clear 1” Scale Remover against the curtain and pour 8 oz. of the product into the reservoir.
How do you clear the Clean light on a Scotsman ice machine?
Push and release the Clean button once every ten minutes for a total of ten minutes. After pressing the Clean button, a light will illuminate, signaling that the rinse procedure has begun. It is necessary to conduct the rinse cycle because it will completely flush out all of the Scotsman Ice Machine Cleaner from the water supply system. This rinse cycle should take no more than 20 minutes total.
How do you fix code 2 on a Scotsman ice machine?
2 (flashing) – Auger motor is under a lot of strain. Retrying. 3 – There is no water in the reservoir. 4 – Excessive or insufficient refrigeration pressure.
How do I reset my Scotsman cm3 ice machine?
Once you’ve identified the control panel, resetting the machine is as simple as pressing and holding the “off” button until the machine shuts off. Once you have waited a short period of time (10 seconds should be plenty), press and hold the “on” button for a short period of time.
How often should you clean Scotsman ice machine?
It is recommended that every ice machine be cleaned and disinfected at least twice a year, even if the water is of excellent quality. Machines must be cleaned more often in some applications, such as those where the air or water quality is poor. Even ice machines that are fitted with purge valves must be cleaned at least once every six months to ensure proper operation.
What does Code 2 mean on Scotsman ice machine?
Diagnostic Codes are a type of code that may be used to diagnose a problem. 2 – A lengthy harvesting period. The system is being shut down. 2 (flashing) – Attempting a second time with a lengthy harvest cycle. 3 – The water is steadily filling.
Why isn’t My Scotsman ice machine making ice?
The presence of low room temperature – Most Scotsman ice producers will not manufacture ice if the temperature in the room is below 55 degrees Fahrenheit. Place the machine in a warmer room or in a more comfortable environment. Lower than normal refrigerant charge — A low refrigerant charge might make ice formation more difficult.
What does short freeze mean on ice machine?
On a Scotsman, Code 8 indicates that there is a brief freezing period. This is caused by the following factors: Inappropriate water flow Because of the growth of scale on the ice thickness sensor, water is splashing over it. Inaccurate readings from the ice thickness sensor An ice thickness sensor that has been shattered, deformed, or uninstalled. Follow the steps outlined below to thoroughly clean the spillway surface.
How do I reset my ice maker?
Turn the ice maker on and off many times. It is as simple as resetting the power to your ice machine to correct the situation. In certain cases, turning the switch off and back on may be enough to restore functioning to your ice maker and get it to start dispenseing again.
How long does it take for a Scotsman ice maker to make ice?
9. After approximately 20 minutes, the machine will start to release the ice, which is referred to as the harvest cycle. Keep an eye out for the first cube harvest: Check the size of the ice cubes before using them.
How do you turn off a Scotsman ice maker?
Procedures for shutting down the Scotsman Flaker and Nugget Machine
- By unlocking the door, you may have access to the power buttons.
- Continue to press and hold the red “OFF” button until the machine shuts down and the green status light goes out. Remove the ice from the machine’s ice bin or ice dispenser. Turn off the water feed to the washing machine.