- To check that the light switch is not stuck in the closed position, wiggle it back and forth and push it in and out to free it from the closed position. The light switch is attached to the mainframe at the top. The light switch is located on the left-hand side of the switch panel. When a switch becomes stuck, do not apply lubrication.
Why is my Sub Zero refrigerator light off?
If the temperatures on the display are dim, it is possible that the equipment is in Sabbath Mode. Instructions on how to exit Sabbath Mode may be found in the Sabbath Mode Information section. If the door is left open for an extended period of time, the light terminator function can be activated, which will turn out the lights. For information on how to reset light terminators, see Light Terminators.
How do you change a lightbulb in a Subzero refrigerator?
Remove the old bulb from the top of the drawer compartment by twisting it in the opposite direction of the clock. Replace the old appliance bulb with a new 25-watt appliance bulb and twist it clockwise to secure it in place. Pushing the light diffuser down into its slots will return it to its original position. Return the shelf and/or drawer to their original positions.
Why is my fridge light not on?
Turning counterclockwise will remove the old bulb located at the top of the drawer compartment. Twist the appliance bulb clockwise to secure it in place before replacing it with a new 25-watt bulb. By pulling the light diffuser down into its slots, you may return it to its original position. Remove your hand from the shelf and/or drawer and place it back in its original location again.
How do I turn my Sub Zero back on?
To switch on an electronic control panel, push the On/Off button or the Power button until the gadget comes to life. When the device is turned off, certain models display “O FF.” On dial models (200/300, 500), check to see that the dial has not been switched to the “OFF” position.
Why did my Sub Zero stopped working?
Check to verify that the power cable is firmly connected to the unit’s electrical socket. Unplug the unit and re-plug it into the outlet. Check to see if the electrical outlet is operational. Test with a different appliance, extension cable, or phone charger to see if the problem persists.
How do you remove a light diffuser?
Removal of the Light Diffuser
- The diffuser may be removed by lifting the center of each of the front tabs and pushing the diffuser toward the rear wall. Take a look at the image below. There are two tabs, one on each side of the screen, one on each side of the screen. Make a little downward bend on the front edge of the diffuser. Remove the diffuser from the appliance by pulling it forward.
How do I know if my fridge has no light?
The presence of warm food or a defrosting freezer are the most evident symptoms that a refrigerator is not working properly. If your refrigerator has a water or ice dispenser, look for power lights on the dispenser if it is equipped with one. Open the doors and look inside to see whether there are any lights. Keep an ear out for the sounds of the fan operating.
Where is the fridge light?
When you open the fridge door, the light is turned on because the door switch is depressed, signaling to the fridge that it should do so. This little switch is normally located towards the top of the door, within the fresh food compartment, and is usually installed in the plastic liner of the interior of the refrigerator.