- Access the water filter by pulling out on the bottom edge of the grille assembly and tilting it forward, as shown in the illustration. Remove the old filter by putting the cartridge into the filter and pulling it out of the filter. It is possible that a tiny amount of water in the filter cartridge will leak out.
Does the Sub-Zero 685 have a water filter?
All other Sub- Zero products do not come with a water filter as standard. Among the units in the 600 Series that do not contain a water filtration system are the 601, 611, 632, 642, 650, 661, 680, 685, 690-695, and 695.
Do Sub-Zero fridges have water filters?
All other Sub-Zero appliances do not include a water filter. Although it is not possible to install an internal water filtering system, it is possible to install a home In-Line Water Filter. For information on how to install an aftermarket water filter in any of these models, go to the In-Line Water Filter Information section of this manual.
Where are water filters in fridge?
The majority of water filters may be found in the grille at the bottom of the refrigerator or at the rear, upper-right corner of the refrigerator’s interior, depending on the model. Some types, mainly older models, have the filter on the exterior of the refrigerator, near the water supply line, in the rear of the refrigerator.
What does Sub-Zero water filter do?
In most refrigerators, the water filter can be found in one of two places: in the grille at the bottom or in the back of the refrigerator, in the upper right corner of the interior. A filter located on the outside of the refrigerator at the back of the unit, near the water supply line, is found on some models, typically older models.
How do I reset my Sub-Zero water filter?
Five seconds of pressing and holding the white filter reset button to the left of the water filter on the front of the condenser cover will reset the water filter life monitor. The water filter life monitor will then be reset.
How do I change the filter in my Sub-Zero ice maker?
If you want to remove the water filter, open the ice maker door and look for it on the bottom-left side of the unit. Make a quarter turn counterclockwise to release the cartridge from the printer’s cartridge holder. Make use of a jar opener to assist you get a stronger grip on a difficult-to-remove filter. Installing the new water filter requires a reversal of the procedure.
How do you turn off the change filter light on a Sub-Zero ice maker?
To turn off the Replace Filter light, follow these steps:
- After replacing the filter, hold down the CLEAN key for 6 seconds to reset the counter and light. If the counter and light do not reset the first time, repeat the process.
When should I change my Sub-Zero air filter?
It is recommended that air purification filters be replaced anytime the indication light begins to flash, which is generally once a year. It is typical to have a continuous indication light on. If the air filter is not updated or if the Sub-Zero unit is not utilized, there is no damage to the device.