- When using a Whirlpool refrigerator, how do you reset the h20 light? What is the best way to re-establish my filter status? Press and hold the button for 3 seconds to complete the task. The status light will turn off after the system has been reset.
How do you reset the water filter light on a Whirlpool refrigerator?
Reset the state of the water filter once it has been changed. For 3 seconds, press and hold the “WATER FILTER” button on the remote control. Following a reset, the water filter symbol returns to its original BLUE color and the words “Replace Filter” are no longer visible on the display.
Where is the reset button on a Whirlpool refrigerator?
Open the refrigerator door and search for the door switches on the inside of the door. Within 10 seconds, press the door switches three times and the refrigerator temperature button three more times. After releasing the switches, a letter “S” should appear on the display in the freezer area and a “E” should appear on the display in the refrigerator section.
Where is the water filter in a Whirlpool side by side refrigerator?
Your water filter cover may be found in the top right-hand corner of your refrigerator or in the base grille of your refrigerator. Raise the filter door as far as it will go. Remove the filter from the machine and throw it away.
How long do I unplug my fridge to reset it?
Normally, I’d unplug it for about 5 minutes at a time. This allows for the equalization of the refrigerant pressures in the system. It should also provide enough time for the circuits to reset.
Do you have to turn the water off to change a refrigerator water filter?
No, there is no need to shut off the water supply.