Reset the state of the water filter once it has been changed. For 3 seconds, press and hold the “WATER FILTER” button on the remote control. Following a reset, the water filter symbol returns to its original BLUE color and the words “Replace Filter” are no longer visible on the display.
How do you reset the filter on a Maytag refrigerator?
If the CHANGE FILTER indicator light does not blink, press and hold the LOCK and LIGHT keypads until the CHANGE FILTER indicator light blinks again (approximately 3 seconds). The light’s control has been adjusted for another 12 months or 416 gallons of water use, whichever comes first.
How do I reset my Maytag plus refrigerator?
How Do I Reset the Front Panel of a Maytag Refrigerator?
- Holding down the power save and lights buttons at the same time for around 8 seconds is recommended. Press and hold the red/freezer buttons for roughly 8 seconds. Hold down the vacation and quick-freeze buttons at the same time for 8 seconds.
How do I reset my Maytag ice maker?
Try a Simple Reset to see if that helps. Your ice maker, like your PC, may benefit from the tried-and-true method of turning it on and off. Immediately before proceeding down this list, switch off the refrigerator’s electricity for a minute and then turn it back on. If the problem is not due to a mechanical or component failure, this simple repair may be sufficient to restore functionality to your ice maker.
How do you get a stuck water filter out of a Maytag refrigerator?
If the water filter becomes clogged,
- While the water filter is being expelled, hold down the button for several seconds. The filter should be activated first, followed by the button. In order for the filter to disengage from the filter assembly, Remove the bottom grill from the refrigerator by unplugging it and following the steps in the Installation Instructions.
How do you reset the water filter light on a Frigidaire refrigerator?
How can I reset the filter light on my refrigerator?
- Amana – Press and hold the “Auto” and “Dispenser Lock” buttons for a few seconds until the water filter status indicator light starts flashing. Frigidaire – Press and hold the “Reset” button for several seconds. To reset your GE (General Electric) appliance, press and hold the “Reset” button for 10 seconds.
How do I reset the water filter light on my Whirlpool refrigerator?
Reset the state of the water filter once it has been changed. For 3 seconds, press and hold the “WATER FILTER” button on the remote control. Following a reset, the water filter symbol returns to its original BLUE color and the words “Replace Filter” are no longer visible on the display.
What does Reset water filter mean?
For 3 seconds, press and hold the “WATER FILTER” button on the remote control. Following a reset, the water filter symbol returns to its original BLUE color and the words “Replace Filter” are no longer visible on the display.
Why is my water filter light still on?
There is an extremely little risk that a water filter will be faulty. As an alternative, one of the most frequently encountered issues is that the change light has to be reset. Typically, this light serves as a timer, reminding you to change your filter every 3 to 6 months as recommended.
How much water should a new fridge filter run?
Water should be run through the new filter in batches of two to four gallons. This helps to keep your water dispenser from sputtering and removes any pollutants that may have accumulated during production.
How do you put a Maytag refrigerator in diagnostic mode?
Entering the Service Test Mode can be accomplished by following the steps outlined below.
- In order to set an alarm, open the fresh food door and press and hold the door alarm keypad DoorAlarm. In order to set an up temperature in the refrigerator, press and hold the refrigerator temperature up keypad. Releasing the Door Alarm Keypad DoorAlarm and waiting for three seconds. Press the UP Keypad on the refrigerator one again.