Press and hold the TEMP SET button on the refrigerator’s control panel for several seconds. When the letter ‘Er’ appears on the screen, press and hold the TEMP SET button. When the letter ‘CL’ appears on the screen, wait five seconds before pressing and holding the TEMP SET button until the letter ‘Er’ appears on the screen once more. Check to see whether the “no co” problem has been resolved by turning the refrigerator on and off.
Why is my Norcold refrigerator not working?
In order to determine the polarity of the DC power supply, you must first check the fuse, which is positioned in-line with the DC connection. If the refrigerator continues to malfunction, it is possible that an issue with the inverter has arisen. Have the refrigerator inspected by a Norcold Service Center that is authorized to do so.
How do you reset a norcold 1200 refrigerator?
Open the refrigerator door and look inside for the control panel, which is located between the frozen food and fresh food compartments in the fridge. Simply press and hold the “On/Off” button for a few seconds before releasing the button. Wait a few minutes and then push the “On/Off” button to bring the power back on again. The refrigerator will be reset as a result of this.
Why won’t my refrigerator work in my RV?
The first important step for troubleshooting an RV refrigerator is to make sure that your motorhome is fully level. Your trailer, camper, or motorhome’s leveling system may be adversely affected if it is not level. If the refrigerator is turned off, the fluid will not flow. Over time, silt will accumulate in the cooling system, causing it to become inoperable.
What does no fl mean on a Norcold refrigerator?
“No Fl” does, in fact, imply that there is no flame. If you have the fridge set to operate on auto and there is no 120v power available, it will attempt to run on LP to conserve energy. If the flame does not ignite or does not burn for whatever reason, you will see the message “No Fl.” It’s possible that you’ll need to clean the burner tube.
How do you fix a refrigerator that is not cooling?
Is your refrigerator still not cooling? Follow These Steps to Diagnosise and Correct the Problem
- The condenser coils are covered in dust. Cooling and condensing of the refrigerant is accomplished via coils situated beneath or behind the refrigerator. The condenser fan is not working properly. The evaporator fan is not working properly. The evaporator coils are completely coated in frost. The air inlet damper is not functioning properly.
How do I reset my Norcold recall kit?
To put it another way, the Norcold temperature sensor is not warm. If you unplug the temperature sensor connector located between the +12VIN and +12VOUT wires and add a jumper between these wires, you can deceive the control into thinking that the temperature sensor is not connected. A powerful magnet held for more than 5 seconds should be sufficient to reset the control.
How do you reset a Norcold 2118 refrigerator?
The relay is housed in a huge black rectangular box to the left of the red LED. The limit/reset switch is located in the upper right hand corner. You must hold the magnet in place for approximately 8 seconds in order to reset the switch. Make sure the power is turned on. As soon as the red light turns off, the switch is reset.
How do you jump a Norcold RV refrigerator?
Before you may jump the pin terminal to ground, the refrigerator must be turned on and displaying the error code. Tent the jumper wire in place between the pin and the ground for approximately 10 seconds, or until you hear an audible click.