Reset the state of the water filter once it has been changed. For 3 seconds, press and hold the “WATER FILTER” button on the remote control. Following a reset, the water filter symbol returns to its original BLUE color and the words “Replace Filter” are no longer visible on the display.
- To reset the change filter light on your Maytag refrigerator, turn on the light and lock keys while holding them down. In some models, the ‘light’ key will not be present
- instead, the ‘water’ and ‘lock’ keys will be required. A flashing change filter light will indicate that the system has been reset after about 3 seconds.
How do you reset the filter light on a Maytag refrigerator?
On your Maytag refrigerator, press and hold the ‘light’ and ‘lock’ keys at the same time to reset the change filter light. Some models may not have a ‘light’ key, in which case you will need to use the ‘water’ and ‘lock’ keys to operate the machine instead. A flashing change filter light will indicate that the filter has been reset after about 3 seconds.
How do I reset my Maytag plus refrigerator?
How Do I Reset the Front Panel of a Maytag Refrigerator?
- Is It Possible to Reset the Front Panel of a Maytag Refrigerator?
How do you turn off the light on a Maytag refrigerator?
Refrigerator with a Cooling Off Indicator Light (Side by Side Refrigerator)
- Continue to press and hold the LOCK and MEASURED FILL buttons at the same time for three seconds. To turn cooling back on, press and hold the LOCK and MEASURED FILL buttons for 3 seconds.
How do you put a Maytag refrigerator in diagnostic mode?
Entering the Service Test Mode can be accomplished by following the steps outlined below.
- In order to set an alarm, open the fresh food door and press and hold the door alarm keypad DoorAlarm. In order to set an up temperature in the refrigerator, press and hold the refrigerator temperature up keypad. Releasing the Door Alarm Keypad DoorAlarm and waiting for three seconds. Press the UP Keypad on the refrigerator once more.
How do I reset my Maytag ice maker?
You must first remove the ice tray in order to have access to it. You should be able to see the bright red reset button on the bottom of the ice maker once you have completed this procedure. This button must be pushed in and held down for 10 seconds to reset the ice maker.
How do you reset a refrigerator after changing filter?
It is necessary to locate the multi-function button(s) on your display that control the water filter indication in order to restore it to its default setting. Then push and hold the button(s) for a few seconds until the light turns green.
Do you have to turn the water off to change a refrigerator water filter?
No, there is no need to shut off the water supply.
Where is the reset button on Frigidaire refrigerator?
The reset button on your Frigidaire Freezer is most likely located on the interior of the appliance. You should unplug your Frigidaire freezer for 15 to 20 minutes before plugging it back in again when you’re resetting it. After that, press and hold the alarm reset button for three seconds, followed by three presses of the down arrow and one push of the up arrow.
How much water should a new fridge filter run?
Water should be run through the new filter in batches of two to four gallons. This helps to keep your water dispenser from sputtering and removes any pollutants that may have accumulated during production.